Hi, I'm having problems with the gx200 clone engine that I am running. On cold start up, the engine starts 2nd or 3rd pull with the choke fully on. As soon as the engine starts I have to close the choke to about half or the engine will cut out. After a few minutes warm up, the engine will stall on any amount of throttle. Its like a 'flat spot'. I can only then start the engine on full choke. I have tried cleaning the carb out and blowing through the jets but without success.I am not sure if I have the mixture control jet set right. It is at two full turns out. I have tried adjusting it when the engine is running but without any difference. Any advice will be gratefully appreciated. Many thanks Steve
|
|